User's Guide

Configuring the Ports
81
Validating Accept Status of a Sub Station
This section applies only if you set ADP mode to Manual Acceptance. Use screen
1.2.3.1.4 ADP Substation Configuration to validate the accept status for each sub sta-
tion listed. The screen only shows sub stations that have not yet been accepted by the
base station. Once they are accepted, they appear in screen 2.5.2 RF-DLC Sub Port
Status, described in detail on page 143.
1.2.3.1.4 ADP Substation Configuration
Record Type [swRFBaseSubPortType] •
••
• Valid
ValidValid
Valid
• Invalid
Indicates the status of this RF Sub station port configuration. If valid, this port config-
uration is enabled. If marked as invalid, this record will be deleted after the next
reset.
Field Name MIB
Settings (default in
bold)
Sub Station Number [swADPStationIndex]
The base sub port number of the sub station.
Field Name MIB
Settings (default in
bold)
1.2.3.1.4 ADP Substation Configuration Record 1 of 1
Sub Station IP Accept
Number Address Status
--------- --------- -------
256 196.028.145.069 No
\ - return to menu . - commands TAB - next available field ENTER - edit