User Manual

Setting
Setting
＞Min SOC：
30%
Backup mode
Backup mode
＞Charge battery to
50%
94
95
g ) Charge and discharge time
Here you can set the charge and discharge time period.
If two charging and discharging periods are needed, turn on the charging
and discharging period 2 and set the period.
h ) Dry Contact
When the user uses the inverter communication control external device
function, you can enter here to set the parameters of the external
response control. For the setting method, please refer to the user manual
of the compatible external device.
If the user uses the inverter dry contacts to control external devices (such
as heat pumps) through the Adapter box, please refer to the Adapter box
quick installation manual to set the parameters here.
＞ Charge
Start Time
00:00
Char&Disc Period
＞ Charge
End Time
00:00
Char&Disc Period
＞Allowed Disc Period
Start Time
00:00
Char&Disc Period
＞Allowed Disc Period
End Time
23:59
Char&Disc Period
＞Char&Disc Period2
Char&Disc Period
＞Function Control
Enable
Char&Disc Period2
Char&Disc Period2
＞ Charge
Start Time
00:00
Char&Disc Period2
＞ Charge
End Time
00:00
＞Allowed Disc Period
Start Time
00:00
Char&Disc Period2
＞Allowed Disc Period
End Time
00:00
Char&Disc Period2
I ) User Password
The default password for the end user is "0000", where you can reset the
new password and press the up/down key to increase or decrease the
value. Press "Enter" to confirm the value and jump to the next digit. When
all passwords have been entered and confirmed, press "OK" to set the
password successfully.
＞
0 0 0 0
User Password
Switch
ON OFF
Load Management
＞ Mode Select
SmartSave
Load Management
Thresholds on
Feedin power
3000W
Load Management
Load Management
Load Management
Minimum duration
per on-signal
5 M
Load Management
Thresholds off
Consumption
500W
Thresholds off
Battery SoC
40%
Minimum duration
per day
900 M
Load Management
＞ Schedule
Enable Disable
Load Management
Work Period 1
Start time
00:00
Load Management
Load Management
Load Management
Load Management
Work Period 1
End time
00:00
Work Period 2
Start time
00:00
Work Period 2
End time
00:00
＞ Mode Select
Disable
Load Management
＞ Mode Select
Manual
Load Management