User Manual

Ø Step 3: Tighten the inverter and bracket
e ) Hang the buckle on the inverter to the corresponding position of the
backplane;
f ) Use the inner hexagonal wrench to tighten the inner hexagonal screw
on the right side of the inverter.
Ø Step 2: hang the inverter on the bracket
c) Insert expansion bolt into the hole, use rubber hammer to knock the
expansion screw bolt into the wall;
d) The bracket is aligned with the screw uses the inner hexagonal wrench
to screw the tapping screw until the expansion bolt "bang" is heard.
InstallationInstallation
c)
Hammer
Expansion bolts, Tapping screws,
30
31
b)
65.00 mm
Φ8 Drill
(Depth: 65 mm)
d)
nut, Gasket,
e)
Inner hexagonal wrench
(Torque:1.2±0.1 N· m)
f)