Installation Guide

SolaX Adapter Box
Quick Installation Guide
Packing List
- Check that if there is any distortion or impaired during
transportation.
SolaX Adapter box is matched with a heat pump with dry
contact function, which can realize heat pump integrated
photovoltaic inverter energy system management. The
inverter can control the Adapter box to use solar energy
efficiently according to the requirements set by the user (grid
power, battery capacity, time, etc.) Supplying heat pumps is
generally applicable when there is surplus solar energy and
battery storage capacity. This part of the energy can be used
to heat the heat pump within the required temperature
range. Please read this guide carefully before using.
Mounting
III
Introduction
I
- Dismantle the upper cover of the SolaX Adapter Box.
- Pass the expansion screws through box installation channels.
Screw the expansion screws.
Quick installation
guide X1
Expansion tubes X4
Expansion screws X4
Hot water
Heat pump
80mm
130mm
113mm
62mm
Overview
II
φ6 Drill
(Depth :30 mm)
IV
62mm
113mm
- Drill holes withφ6 drill.
Depth: at least 30mm.
- Tighten the expansion tubes.
01
Slotted screwdriver
torque:1.5±0.1Nm
NO
1 2 3
NO
1 2 3
NO
1 2 3
V
Pictorial wiring diagram:
K4
K3
K2
K1
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
Inverter
Heat pump
Note: Adapter Box is generally suitable for heat
pumps with dry contact function. K3/K4 needs
to be connected to the dry contact on the heat
pump to control it.
Wiring
Inverter
Heat pump
K3
K4
NO
1 2 3