Installation Guide

X3-PRO G2 Series 8 kW-30 kW
Packing List
Inverter Installation
- Mark the position of three holes.
- Drill holes with φ10 drill.
- Depth: at least 60 mm.
- Tighten the expansion tubes.
- Screw the expansion screws. - Match the inverter with the bracket.
Note: Please refer to the appropriate instruction manual for the usage
of Pocket WiFi and optional products.
7.0 mm
Stripping pliers
Wire crimper
Wire crimper recommended model:
H4TC0001
manufacturer: Amphenol
Tools:
X3-PRO G2
series inverter 1*
OT terminal *5
Terminal cover *5
PV terminal *8/12
PV pin contact *8/12
M5 inner hexagonal screw *1
Terminal block *1, RJ45 connector *1
Terminal sleeve *1, R-type terminal *1
(Expansion bolt, Gasket,
Self-tapping screw) *3
Bracket 1*
Product manual *1
Quick installation guide *1
Pocket WiFi/
LAN (Optional) /4G (Optional)
Meter (Optional)
Torque 1.2 0.1 N·m: ±
- Align the PV connectors.
strip length
X3-PRO G2 Series 8 kW-30 kW
60.00 mm
Φ10 Drill
(Depth: 60 mm)
Expansion bolts
Rubber hammer
Outer hexagonal wrench
cable size: 2.5-4 mm
f )
Inner hexagonal wrench
(Torque:1.2±0.1 N·m)
6
- Use the inner hexagonal wrench to
tighten the inner hexagonal screw on
the right side of the inverter.
AC waterproof cover *1
X3- PRO G2 Se ries
User Manual
8 kW - 30 kW
Copyright Declaration
The copyright of this manual belongs to SolaX Power Network Technology (Zhejiang) Co., Ltd. Any
corporation or individual should not plagiarize, partially or fully copy (including software, etc.),
and no reproduction or distribution of it in any form or by any means shall be allowed. All rights
reserved. SolaX Power Network Technology (Zhejiang) Co., Ltd. reserves the right of final
interpretation.
positive PV
pin contact
negative PV
pin contact
cable
cable
clamp contact
clamp contact
tighten nut
male plug
nut
female plug
nut
tighten nut
For inverters with two strings of MPPT, there are 4 positive and 4
negative PV terminals and PV pin contacts respectively. For inverters
with three strings of MPPT, there are 6 positive and 6 negative PV
terminals and PV pin contacts respectively.