Installation Guide

EV-Charger 7.2 kW-22 kW
Packing List
Installation Steps
EV-Charger *1
Expansion bolt *3/5
(3 for type S, 5 for type P)
Manual *1
European terminal *3/5
(3 for single-phase;
5 for three-phase)
CT (single-phase)
*1
RJ 45 terminal adapter
*1
Cable hook *1
(only for type P)
Quick Installation Guide
*1
CT(three-phase)
*1
STEP 1: Remove the screw from the EV-Charger with the cross screwdriver. Then remove the back bracket away carefully.
STEP 2: Fix the back bracket and the cable hook (only for type P) to the wall.
- Mark the position of the holes.
- Insert the expansion bolts.
- Drill holes with φ 8 drill.
- Depth: at least 45 mm.
- Align the bracket and the cable hook (only for type P) with
the holes, and screw the self tapping screws with the cross
screwdriver.
STEP 3: Hang the EV-Charger on the wall for trial, then estimate the required length of input cable (three-core for single-phase, five-core for
three-phase, outer diameter: 12.5-18 mm) and communication cable. After that, take the EV-Charger down.
STEP 4: Unscrew the EV-Charger’s rear cover with the cross screwdriver and take it down. the fastening heads and take the Then undo
waterproof materials away as shown below.
STEP 5: Unscrew the countersunk screw of the base plate of communication board with the cross screwdriver. Then pull the base plate of
communication board out .
EV-Charger 7.2 kW-22 kW
EV-Charger User Manual
7.2 kW - 22 kW
Copyright Declaration
The copyright of this manual belongs to SolaX Power Network Technology (Zhejiang) Co., Ltd.
Any corporation or individual should not plagiarize, partially or fully copy it (including
software, etc.), and no reproduction or distribution of it in any form or by any means shall be
allowed. All rights reser ved. SolaX Power Network Technology (Zhejiang) Co., Ltd. reser ves the
right of final interpretation.
Self tapping screw *3/5
(3 for type S, 5 for type P)
Gasket *3/5
(3 for type S, 5 for type P)
RFID Card *2
≥400 mm
(torque:1.5~2 N·m)
②
①