Installation Instructions

Sunrise
Solartech
Co.,
Ltd
Tel:[phone] Fax:[phone]
Website:www.srsolartech.cn
ADD: No.65-22 Xinggang Road, ZhongLou Development Zone, Changzhou 213023 Jiangsu, P.R.China
5
/11
Selecting the proper support frame
Always observe the instructions and safety precautions included with the support frames to be
used with the modules.
Do not attempt to drill holes in the glass surface of the modules. To do so will void the warranty.
Do not drill additional mounting holes in the frame of the modules. Doing so will void the
warranty.
Modules must be securely attached to the mounting structure using four mounting points for
normal installation. If additional wind or snow loads are anticipated for this installation,
additional mounting points are also used. The details please see the below drawing. Load
calculations are left to the system designers or installers.
Mechanical Installation
The support module mounting structure must be made of durable, corrosion-resistant and
UV-resistant material.
Ground mount
Select the height of the mounting system to prevent the lowest edge of the module from being
covered by snow for a long time in winter in areas that experience heavy snowfalls. In addition,
assure the lowest portion of the module is placed high enough so that it is not shaded by plants
or trees or damaged by sand and stone driven by wind.
Roof mount
When installing a module on a roof or building, ensure that it is securely fastened and cannot
fall as a result of wind or snow loads.
Provide adequate ventilation under a module for cooling (10cm minimum air space between
module and mounting surface).