Installation Instructions

Sunrise
Solartech
Co.,
Ltd
Tel:[phone] Fax:[phone]
Website:www.srsolartech.cn
ADD: No.65-22 Xinggang Road, ZhongLou Development Zone, Changzhou 213023 Jiangsu, P.R.China
4
/11
Pmax under standard test conditions (irradiance of 100mW/cm2, AM 1.5 spectrums, and a cell
temperature of 25°C (77°F))
Under normal outdoor conditions the module will produce current and voltages that are different
than those listed in the date sheet. Data sheet values are values expected at standard test
conditions. Accordingly, during system design, values of short-circuit current and open-circuit
voltage should be multiplied by a factor of 1.25 when determining component voltage ratings,
conductor ampacity, fuse ratings and size of controls connected to the modules or system output.
Product identification
Each module has three labels on its rear side providing the following information:
Nameplate: describes the product type; rated power, rated current, rated voltage, open circuit
voltage, short circuit current, all as measured under standard test conditions; weight, dimension
etc.; the maximum system voltage 1000 volts DC and is shown on the nameplate. Maximum
fuse rating is also shown.
“Pass”: describe inspection date and security class.
Bar code: each individual module has a unique serial number. The serial number has 17 digits.
There is only one bar code on module. It is permanently attached to the interior of the module
visible when viewing from the front of the module. This bar code is inserted at the beginning of
laminating.
Typical serial number barcode label
Do not remove any label.
If the label is removed, the product warranty will no longer be honored by Sunrise.
Mechanical Installation
Selecting the location
Select a suitable location for installing the modules.
The modules should be facing south in northern latitudes and north in southern latitudes.
For detailed information on the best elevation tilt angle for the installation, refer to standard
solar photovoltaic installation guides or a reputable solar installer or systems integrator.
The module should not be shaded at any time of the day.
Do not use module near equipment or in locations where flammable gases can be generated or
collected.