Installation Instructions

Sunrise
Solartech
Co.,
Ltd
Tel:[phone] Fax:[phone]
Website:www.srsolartech.cn
ADD: No.65-22 Xinggang Road, ZhongLou Development Zone, Changzhou 213023 Jiangsu, P.R.China
2
/11
Purpose of this guide
This guide contains information regarding the installation and safe handling of Sunrise
Solartech Co., Ltd photovoltaic module (hereafter is referred to as “module”). Sunrise Solartech
Co., Ltd hereafter is referred to as “Sunrise”.
Installers must read and understand the guide before installation. Any questions, please contact
our sales department for further explanations. The installer should conform to all safety
precautions in the guide and local codes when installing a module.
Before installing a solar photovoltaic system, installers should become familiar with the
mechanical and electrical requirement for such a system. Keep this guide in a safe place for
future reference (care and maintenance) and in case of sale or disposal of the modules.
General
Installing solar photovoltaic systems may require specialized skills and knowledge. Installation
should be performed only by qualified persons.
Each module comes with a permanently attached junction. Sunrise can provide customers with
fitted cables for ease of installation if desired.
Installers should assume the risk of all injury that might occur during installation, including,
without limitation, the risk of electric shock.
One individual module may generate DC voltages greater than 30 volts when exposed to direct
sunlight. Contact with a DC voltage of 30V or more is potentially hazardous.
Do not disconnect under load.
Photovoltaic solar modules change light energy to direct-current electrical energy. They are
designed for outdoor use. Modules may be ground mounted, mounted on rooftops, vehicles or
boats. Proper design of support structures is responsibility of the system designers and installers.
Use of mounting holes is suggested in a following paragraph.
Do not attempt to disassemble the modules, and do not remove any attached nameplates or
components from the modules.