Installation manual

19
Safety, Installation, and Operations Manual
© Solaria Corporation All rights reserved. Contents subject to change without notice 8-26-19
Power Unlocked by Design
D. Insert the cable into the terminator body so that each of the two wires land on opposite sides of the internal
separator.
E. Insert a screwdriver into the slot on the top of the terminator to hold it in place and torque the nut to 7 Nm.
F. Hold the terminator body stationary with the screwdriver and turn only the hex nut to prevent conductors from
twisting out of the separator.
NOTE: Turn only the hex nut to prevent conductors from twisting
out of the separator.
G. Attach the terminated cable end to the PV racking with a cable clip or
tie wrap so that the cable and terminator do not touch the roof.
WARNING: The terminator cannot be re-used. If you unscrew the
nut, you must discard the terminator
Internal View