Installation manual

Safety, Installation, and Operations Manual

Power Unlocked by Design

Step 3: Connect to a Junction Box

A. Connect the Enphase Q Cable into the junction box.

B. Refer to the wiring diagrams on page 44 for more information. Wire colors are listed in the following table.

WIRE COLORS

L1 – Black

L2 – Red

Step 4: Terminate the Unused End of the Cable

Place sealing caps on unused connectors and terminate the unused end of the Enphase Q Cable as follows.

A. Cover any unused connectors with Enphase Sealing Caps. Listen for a click as the connectors engage.

WARNING: Risk of electric shock. Risk of re. Install sealing caps on all unused AC connectors as these

connectors become live when the system is energized. Sealing caps are required for protection against

moisture ingress.

NOTE: If you need to remove a sealing cap, you must use the Enphase Disconnect Tool. See “Remove and

Replace a Microinverter” on page 35.

B. Remove 13 mm (½ inch) of the cable sheath from the conductors. Use the terminator loop to measure 13 mm.

C. Slide the hex nut onto the cable. There is a grommet inside of the hex nut that should remain in place.

Terminator Body 13mm