Installation Manual

Backup Power Only - System Configurations

2 Set the dip switches of Battery 2 to ID 25: Move dip switch 1 to position 1 (to the left), move dip switches 2 and 3 to position

0 (to the right).

Battery 1 – ID 24:

Battery 2 - ID 25:

3 Configure Battery 1 and backup power as described in the Basic Configuration on page 20.

4 Configure Battery 2:

5 Select Communication  RS485-1 Conf  Device Type  Multi-devices. A list of devices is displayed.

6 Select Battery 2. The battery configuration screen is displayed.

7 Configure the battery: Select Device Type  Battery Pack.

Battery 2 is pre-configured to Tesla with device ID 25.

► To verifying communication:

Verify communication as described in the Basic Configuration of page 20.