Installation Manual

Backup Power with Smart Energy Management - System Configurations
17
► To set up Smart Energy Management:
After configuring the meter, battery and backup power, proceed with maximizing self-consumption or charge/discharge profile
programming as described in the Basic Configuration on page 10.
► To verify communication:
Verify communication as described in the Basic Configuration on page 11.
AC Coupling without a PV System
For backup power with charge/discharge profile programming a StorEdge system may be installed without a PV system. In this
case, the battery is charged from the AC grid only.
NOTE
For maximizing self-consumption a PV system is required.
Figure 13: Backup Power with Smart Energy Management - AC coupling without a PV system
► To configure the system:
1 Configure the meter, battery and backup power as described in the Basic Configuration on page 8.
2 After configuring the meter, battery and backup power, proceed with charge/discharge profile programming as described in
the Basic Configuration on page 10.
► To verify communication:
Verify communication as described in the Basic Configuration on page 11.