Install Manual
Table Of Contents
- Disclaimers
- Support and Contact Information
- Revision History
- HANDLING AND SAFETY INSTRUCTIONS
- IMPORTANT SAFETY INSTRUCTIONS
- Chapter 1: Introducing the SolarEdge Power Harvesting System
- Chapter 2: Installing the Power Optimisers
- Chapter 3: Installing the Inverter
- Chapter 4: Connecting the AC and the Strings to the Safety Switch
- Chapter 5: Activating, Commissioning and Configuring the System Using the Inverter SetApp
- Chapter 6: Setting Up Communication
- Appendix A: Errors and Troubleshooting
- Appendix B: Mechanical Specifications
- Appendix C: External Fan Maintenance and Replacement
- Appendix D: Replacing and Adding System Components
- Technical Specifications - Three Phase Inverters (North America)
2.
IdentifythefuselocationsandthemarkingsasdescribedinFigure21.
Figure 21: Fuse locations and markings
3. Removethedummyfusefromthe3-wiregridfuseholderandsetitaside.
4. Movethefusefromthe4-wiregridfuseholdertothe3-wiregridfuseholder.
5. Placethedummyfuseinthe4-wiregridfuseholder.
6. Duringsystemsetup,setthecountrytotheappropriate3-wiregridoption.Usingthenon-3-wire
settingmayresultinincorrectsystemoperation.
CAUTION!
If the fuse was moved to support one of the grid types, do not connect the inverter to the other grid type
without switching the fuse back to the correct holder. Connecting the inverter to grids when the fuse is
incorrectly located may damage the inverter and void the warranty.
Si le fusible a été déplacé pour supporter l’un des types de réseau, ne branchez pas l’onduleur sur l’autre
type de réseau avant de remettre le fusible dans son bon support. Brancher l’onduleur au réseau quand
le fusible est mal placé, peut endommager l’onduleur et annuler la garantie.
Connecting the AC Grid to the Safety Switch
CAUTION!
Donotremoveordisconnectthemeterduringinverterinstallation.
ATTENTION!
Ne pas enlever ou débrancher le compteur pendant l’installation de l’onduleur.
CAUTION!
When moving the pivoting plate, make sure that the wires are not strained to avoid loosening the
connections. When flipping the plate up to its original position, check for loose wires or connectors, and
when closing the inverter, recheck for proper functionality as described in this procedure.
ATTENTION!
Si vous faites pivoter le couvercle du compteur, faites attention de ne pas tendre les câbles au point
d’affaiblir les connections. Quand vous remettrez le couvercle à sa position originelle, vérifiez que les
câbles ou les connecteurs ne sont pas détachés, et quand vous refermerez l’onduleur, revérifier son
fonctionnement tel qu’il est décrit dans cette procédure.
NOTE
l Use only copper conductors rated for a minimum of 90°C/ 194°F.
l For the SE10KUS, SE20KUS, SE33.3KUS three phase inverters where opposite polarity DC
conductors are routed in the same conduit, 1000V rated cables must be used.
Chapter 4: Connecting the AC and the Strings to the Safety Switch
-Three Phase System Installation Guide MAN-01-00527-1.1
35