Manualshelf

SE9K SetApp Enabled Manual

ManualsBrandsSolarEdge ManualsGrid Tie InvertersSetApp Enabled SE9K Gridtied Inverter - 3 Phase 208V
41424344454647484950
Fasten the bracket using a standard bolt.
Verify that the bracket is firmly attached to the mounting surface.
Figure 18: Safety Switch bracket
9. Insert the two supplied screws through the outer heat sink fin on both sides of the
inverter and into the bracket (see
Figure 17
). Tighten the screws with a torque of 4.0
N*m / 2.9 lb.*ft.
-Three
Phase
System
Installation
Guide
MAN-01-00527-1.2
40 Mounting the Inverter