SE9K SetApp Enabled Manual
Supported ACGrids
Figure 2: AC grids supported by SolarEdge three phase inverters
NOTE
Grid support depends on the inverter model. Some three phase inverters
support the 208V 3-wire grid. Refer to
Setting the Inverter to Support 208V 3-
wire Grid
on page 43.
Installation Procedure
The following is the procedure for installing and setting up a new SolarEdge site. Many
of these also apply to modification of an existing site.
1. Connecting Power Optimizers in Strings, page 25.
2. Recording power optimizer serial numbers (optional), page 64.
3. Mounting the inverter, Page 35.
4.
Connecting the strings and the AC to the Safety Switch, page 41.
5.
Commissioning and activating the installation, page 51.
6. Connecting the inverter to the monitoring platform, page 65.
Installation Equipment List
Standard tools can be used during the installation of the SolarEdge system. The
following is a recommendation of the equipment needed for installation:
Allen screwdriver for 5mm screw type for the inverter cover, Safety Switch cover,
and inverter side screws
Standard flat-head screwdrivers set
-Three
Phase
System
Installation
Guide
MAN-01-00527-1.2
14 Supported ACGrids