User Manual
Figure 1: EV cable connection
2. Determine the mounting location, on a wall, stud framing or pole.
Maintain the following minimum clearance areas between the holder and other objects:
8" (20 cm) from the top and sides of the holder
24" (60 cm) - 4 ft (1.2 m) from the bottom of the holder
CAUTION!
Install the cable holder (storage means) between 24-48" (60-120cm) from ground (grade).
ATTENTION!
Installer le support du câble (utilisé pour le stockage) entre 24 – 48'' 60 et 120cm du sol (niveau).
Install the cable colder at minimum height of 0.4m and maximum height of 1.5m from the ground.
3. Position the holder against the wall/ pole and mark the drilling hole locations.
4. Drill the holes.
5. Position the EV Charger Cable (with the plug at the top) in the groove of the holder and attach the holder to the wall
using the screws (See
Figure 2
). This allows cable strain relief.
6. Verify that the bracket is firmly attached to the mounting surface.
Figure 2: Cable connection
7. Hang the cable on the holder. To avoid damage to the cable, do not exert pressure on the cable.
EV Charger Cable Installation and EV Charger Configuration MAN-01-00455-1.2
2 Mounting the EVCharger Cable
Figure 3: Inverter with EVcharger