Installation Guide

WARNING!
If you cannot see the inverter panel, or if a malfunction is indicated on the
LCD panel, wait five minutes for the input capacitors of the inverter to
discharge.
AVERTISSEMENT!
Si vous ne pouvez pas voir l'écran de l'onduleur ou si un dysfonctionnement
est indiqué sur l'écran LCD, attendez cinq minutes pour que les
condensateurs d'entrée de l'onduleur soient déchargés.
2. Turn OFF the Connection Unit and the AC breaker of the distribution panel.
3. Open the Connection Unit cover: Release the four Allen screws and remove the
cover.
4. Open the inverter cover as described in
Removing the Inverter Cover
on page 72.
5. Disconnect the DC wires from the inverter and the ACwires from the Connection
Unit .
6.
Disconnect the wires connected between the inverter and the Connection Unit:
Antenna cable from the communication board
RS485 connection from the communication board
Grounding cable
7.
Open the Connection Unit bracket screws.
Figure 37: Connection Unit bracket
8.
Disconnect the Connection Unit from the inverter by opening the two clips securing
the Safety Switch to the inverter: Carefully place a screwdriver between the clip and
the enclosure and pull the clip.
EV Charging Single Phase Inverter Guide MAN-01-00404-1.2
98 Replacing the Connection Unit