Installation Guide

Figure 36: Mounting brackets
NOTE
If you remove the old inverter and do not immediately install a new one, then:
Lock the Connection Unit in the OFF position using a lock on the switch.
Secure the Connection Unit bracket to the wall/pole, using 3 screws
Use insulation tape to isolate each of the AC and DC wires.
Seal the open conduits using duct tape.
Install the Connection Unit sealing cover supplied with the inverter and
secure with retaining clips.
10. Place the new inverter on the mounting brackets and secure it using the screws.
11. Insert the wires from the Connection Unit into the openings in the inverter and the
ferrite bead.
12. Fasten the two clips securing the Connection Unit to the inverter.
13. Reconnect the cables: Follow the instructions of
Installing the Inverter
on page 29.
14. Close the inverter and Connection Unit covers.
15. Perform the commissioning steps as described in
Commissioning the Installation
on
page 41.
Replacing the Connection Unit
1. Turn OFF the inverter ON/OFF switch, and wait until the LCD indicates that the DC
voltage is safe (<50V), or wait five minutes before continuing to the next step.
Appendix C: Replacing and Adding System Components97
EV Charging Single Phase Inverter Guide MAN-01-00404-1.2