Installation Guide

5. Open the inverter cover as described in
Removing the Inverter Cover
on page 72.
6.
Disconnect the DC and AC cables from the Connection Unit.
Figure 34: DC and AC connections
7.
Disconnect the wires connected between the inverter and the Connection Unit:
Antenna cable from the communication board
DC and AC wires in the Connection Unit
Grounding cable
8.
Disconnect the Connection Unit from the inverter by opening the two clips securing
the Connection Unit to the inverter: Carefully place a screwdriver between the clip
and the enclosure and pull the clip.
Figure 35: Disconnecting the Connection Unit from the inverter
9.
Remove the screws securing the inverter to the mounting brackets and lift the
inverter from the mounting bracket.
EV Charging Single Phase Inverter Guide MAN-01-00404-1.2
96 Replacing an Inverter