Installation Guide

FW Upgrade: Perform a software upgrade by using an SD card.
Refer to upgrading_an_inverter_using_micro_sd_card.pdf.
Diagnostics: Displays the Isolation Status and optimizers status
screens. Refer to http://www.solaredge.us/files/pdfs/application_note_
isolation_fault_troubleshooting.pdf.
AFCI: Enables or disables arc-fault self-test. Refer to
http://www.solaredge.com/sites/default/files/arc_fault_detection_
application_note_na.pdf .
Standby Mode: Enables/disables the Standby Mode - for remote commissioning.
After you set the inverter to the Standby Mode, the batteries will charge until
reaching an SOE of 100% to prevent a critically low SOE. Only then will the
inverter enter the Standby Mode. Each battery charge may take approximately
two hours.
Grid Protection: Available in specific countries. Enables viewing and setting grid
protection values.
Optimizer Conf.: Opens the Rapid Shutdown menu, to enable/disable PVRSS.
Chapter 7: Configuring the Inverter 59
EV Charging Single Phase Inverter Guide MAN-01-00404-1.2