Installation Guide
OK/Enter (3): Selects a menu option and accepts a value change with a long
press (until Applied is displayed).
Use the three rightmost buttons Up, Down and OK sequentially for entering the Setup
mode.
The LCD screen displays status information of the system and various menus for
configuration options. The LCD panel and buttons are used during the following
processes:
Operational mode: The LCD panel allows checking for proper system operation.
Refer to
Status Screens - Operational Mode
on page 61 for a description of this
option. Use the up and down buttons to toggle through the informative
displays.
Setup mode: Upon installation, an installer may perform basic configuration, as
described in
Inverter Configuration – Setup Mode
on page 52.
Error messages: In the event of a problem, an error message may be displayed
on the LCD panel.
For more information, refer to
Errors and Troubleshooting
on page 81 and
Inverter Configuration – Setup Mode
on page 52.
Internal Interfaces
DIPSwitches
The inverter has three sets of DIP switches (see
Figure 24
):
MODBUSAddress DIP switches -
do not change
the position of these switches.
RS485 termination DIPswitch- for use when connecting a meter
Circuit breaker rating DIP switches - set as described below.
EV Charging Single Phase Inverter Guide MAN-01-00404-1.2
50 Internal Interfaces