Installation Guide
Chapter 6: Commissioning the Installation
This chapter describes how to activate the system, pair the poweroptimizers to the
inverter and verify the proper functioning of the system.
Step 1: Activating the System
1. Verify that the inverter ON/OFF switch is OFF.
2.
If not already removed, remove the inverter cover: Open the inverter cover’s six
Allen screws and carefully pull the cover horizontally before lowering it.
WARNING!
ELECTRICAL SHOCK HAZARD. Do not touch uninsulated wires when the
inverter cover is removed.
AVERTISSEMENT!
RISQUE D’ÉLECTROCUTION, ne touchez pas les fils non isolés lorsque le
couvercle de l'onduleur est retiré.
3.
Activate the inverter:
1. Verify that the card S/N matches the inverter S/N.
2. Insert the card into the slot marked "CARD" on the communication board.
3. Turn AC ON.
4.
LCD shows: Running Script... è Done!
Figure 22: Communication board and activation card
If LCDshows: Failed:
Turn AC OFF and ON (reset), and repeat the activation process.
Use the activation code that appears on the certification inverter label to
manually activate the inverter.
If the problem persists, contact SolarEdge Support.
Chapter 6: Commissioning the Installation 41
EV Charging Single Phase Inverter Guide MAN-01-00404-1.2