Installation Guide

Figure 16: Clearance areas
3. Position the mounting bracket against the wall/ pole and mark the drilling hole
locations (refer to Mechanical Specifications on page 93 for inverter and mounting
bracket dimensions).
4.
Drill the holes and mount the bracket. Verify that the bracket is firmly attached to
the mounting surface.
5.
Hang the inverter on the bracket:
a. Lift the inverter from the sides, or hold it at the top and bottom of the inverter to
lift the unit into place. Do not lift holding the Safety Switch as it may be
damaged.
b. Lower the inverter onto the U-shaped indentations, as shown below. Let the
inverter lay flat against the wall or pole.
c.
Insert the two supplied screws through the outer heat sink fin on both sides of
the inverter and into the bracket. Tighten the screws with a torque of 4.0 N*m /
2.9 lb.*ft.
EV Charging Single Phase Inverter Guide MAN-01-00404-1.2
34 Mounting the Inverter