Installation Guide
Chapter 4: Installing the Inverter
Install the inverter either before or after the modules and power optimizers have been
installed.
NOTE
Use only copper conductors rated for a minimum of 75°C/ 167°F.
Inverter Package Contents
One inverter with Connection Unit
Mounting bracket kit
Connection Unit sealing cover (if applicable, for use in case of inverter
replacement)
Installation guide (with activation card and instructions)
Antenna and mounting bracket for wireless communication (in specific models)
Identifying the Inverter
Refer to the sticker on the inverter that specifies its Serial Number and its Electrical
Ratings. Provide the serial number when contacting SolarEdge support. The serial
number is also required when opening a new site in the monitoring platform.
Inverter Interfaces
The following figure shows the inverter connectors and interfaces.
Figure 11: Inverter Interfaces
ACoutput: For connection of the AC grid
DC input : For connection of the PV installation
Chapter 4: Installing the Inverter 29
EV Charging Single Phase Inverter Guide MAN-01-00404-1.2