Installation Guide

Figure 38: Disconnecting the Connection Unit from the inverter
9. Detach the Connection Unit from the inverter.
10. Place the new Connection Unit and secure it to the inverter using the clips.
11. Insert the wires from the inverter into the openings in the Connection Unit and the
ferrite bead.
12. Reconnect the cables: Follow the instructions of
Installing the Inverter
on page 29.
13. Close the inverter cover.
14. Fasten the Safety Switch bracket using a standard bolt.
15. Perform the commissioning steps as described in
Commissioning the Installation
on
page 41.
Appendix C: Replacing and Adding System Components99
EV Charging Single Phase Inverter Guide MAN-01-00404-1.2