Installation Manual

Error #
Single Phase
Error # Three
Phase
LCD
Message
Cause and Troubleshooting
o
If permitted by local authorities, change the grid protection
values. Refer to
http://www.solaredge.com/files/pdfs/viewing_grid_
protection_values.pdf
32, 41
61/62/63,
67/68/69
AC Voltage Too
Low
o
Verify that the inverter is set to the correct country.
o
Consult the grid operator.
o
If permitted by local authorities, change the grid protection
values. Refer to
http://www.solaredge.com/files/pdfs/viewing_grid_
protection_values.pdf
34 79/80/81
AC Freq Too
High (Line
1/2/3)
35 82/83/84
AC Freq Too
Low (Line 1/2/3)
36 72/74/75
DC Injection
(Line 1/2/3)
Contact SolarEdge support.
40 N/A Islanding
AC grid voltage malfunction. When AC voltage returns the
inverter should restart after the reconnection time.
If the problem persists, consult with the grid operator.
43 N/A
Internal HW
Error
Contact SolarEdge support.
44 44
No Country
Selected
Select the country, as described in Country and Grid on page
45.
46
Phase
Unbalance
Select Power Control è Phase Balance è Disable.
N/A 103, 119
UDC Min / DC
Voltage Too
Low
Turn the inverter OFF and ON. If the fault persists, contact
SolarEdge support.
N/A 49
Communication
Error
Contact SolarEdge support.
N/A 78 Grid Sync Error Contact SolarEdge support.
N/A
91/92/93 (TZ
L1/L2/L3),
96/97/98 (Iac
L1/L2/L3
Max).
AC Over
Current Line
1/2/3
Contact SolarEdge support.
N/A 99-101
AC Voltage Too
High Line 1/2/3
Turn the inverter OFF and ON. If the fault persists, contact
SolarEdge support.
N/A 105
Temperature
Too Low
Make sure the inverter is installed in a location with ambient
temperatures within the range specified in the datasheet.
N/A 124
Ground Current
Contact SolarEdge support.
SolarEdge-StorEdge Installation Guide MAN-01-00262-1.0
86
General Inverter Error Codes