Installation Manual

Table Of Contents

Connecting to DC

Connecting the PVStrings

Figure 18: PV connection

1. VerifythattheACcircuitbreakerisOFF.

2. Strip5⁄16''(8mm)oftheDCwireinsulation.

3. InserttheDCconduitintotheDC-sideopening.Makesuretheconduitisfirmlyattachedtothe

inverterenclosureandsealedproperly.

4.

ConnecttheDCwiresfromthePVinstallationtotheDC+andDC-terminalblocks,accordingtothe

labelsontheterminals:

a. Insertaflatbladescrewdriverintothesquareopeningatthetopoftheterminalblockandpress

toopenclampmechanism.

b.

Insertthewireintotheroundopeningandreleasethescrewdrivertospringbackandclampthe

wire.Checkthatthewireisfullyinsertedandcannotbepulledouteasily.

CAUTION!

Ensure that the Plus (+) wire is connected to the Plus (+) terminal and that the Minus (-) wire is

connected to the Minus (-) terminal connector.

Veillez à ce que le câble Plus (+) soit connecté au terminal (+) et que le câble Minus (-) soit

connecté au connecteur terminal (-).

NOTE

For systems with three PV strings or more, fuses may need to be installed in both the positive

and negative conductors as required by Article 690.35(B). For more information, refer to the

Technical Note “String Fusing Requirements in SolarEdge Systems” at

http://www.solaredge.com/files/pdfs/string_fusing_requirements.pdf.

Chapter 6: StorEdge Inverter Connections

SolarEdge-StorEdge Installation Guide MAN-01-00262-1.0