Installation Guide

Appendix C: Replacing and Adding System
Components
NOTE
Ifyouarepermanentlydisassemblingtheinstallationorpartofit,makesuretousethedisposal
methodsdictatedbylocalregulations.
Fuse Replacement
Theinverterisequippedwithafuse,locatedatthetoprightcorneroftheinverter.
FusereplacementkitsareavailablefromSolarEdgeoryoucanuseotherfuseswithidenticalratings.
1. TurnOFFtheinverterON/OFFswitch,andwaituntiltheLCDindicatesthattheDCvoltageissafe
(<50V),orwaitfiveminutesbeforecontinuingtothenextstep.
WARNING!
Ifyoucannotseetheinverterpanel,orifamalfunctionisindicatedontheLCDpanel,waitfive
minutesfortheinputcapacitorsoftheinvertertodischarge.
AVERTISSEMENT!
Si vous ne pouvez pas voir l'écran de l'onduleur ou si un dysfonctionnement est indiqué sur l'écran
LCD, attendez cinq minutes pour que les condensateurs d'entrée de l'onduleur soient déchargés.
2. TurnOFFtheDCSafetyUnit.
3. Openandremovetheinvertercover.
4. Removetheexistingfusefromtheuppercorneroftheinverterandreplacewithanewfuse.
5.
Closetheinvertercover.
Figure 35: Inverter fuse
6.
TurnON:
l TheinverterON/OFFswitch
l TheDCSafetyUnit
7. Verifypropersystemoperation.
Appendix C: Replacing and Adding System Components
Single Phase Inverter with HD-Wave Technology Installation MAN-01-00306-1.1
73