Installation Guide

To connect the Ethernet cable:
1. RemovetheinverterandSafetySwitchcoversasdescribedinRemovingtheInverterCoveronpage54.
2. Openthecommunicationgland#
1.
CAUTION!
Theglandincludesarubberwaterprooffitting,whichshouldbeusedtoensurepropersealing.
ATTENTION!
Le cote interne du gland contient une rondelle qui doit être utilisée pour une bonne étancheïté.
3.
Removetheplasticsealfromoneofthelargeopenings.
4. RemovetherubberfittingfromtheglandandinserttheCAT5/6cablethroughtheglandandthrough
theglandopeningintheinverter.
5. InsertthecablethroughtheopeningintheSafetySwitchtowardsthecommunicationboard.
6. Pushthecableintothecutopeningoftherubberfitting.

Figure 25: Communication glands and rubber fitting
CAT5/6standardcableshaveeightwires(fourtwistedpairs),asshowninthediagrambelow.Wirecolors
maydifferfromonecabletoanother.Youcanuseeitherwiringstandard,aslongasbothsidesofthe
cablehavethesamepin-outandcolor-coding.
RJ45 Pin #
Wire Color
1
10Base-T Signal
100Base-TX Signal
T568B T568A
1 White/Orange White/Green Transmit+
2 Orange Green Transmit-
3 White/Green White/Orange Receive+
4 Blue Blue Reserved
5 White/Blue White/Blue Reserved
6 Green Orange Received-
1
TheinverterconnectiondoesnotsupportRX/TXpolaritychange.SupportingcrossoverEthernetcablesdependsonthe
switchcapabilities.
Single Phase Inverter with HD-Wave Technology Installation MAN-01-00306-1.1
56
Creating an Ethernet (LAN) Connection