Installation Guide

Chapter 5: Commissioning the Installation
Thischapterdescribeshowtoactivatethesystem,pairthepoweroptimizerstotheinverterandverify
theproperfunctioningofthesystem.
Step 1: Activating the System
1. VerifythattheinverterON/OFFswitchisOFF.
2.
Ifnotalreadyremoved,removetheinvertercover:Opentheinvertercover’ssixAllenscrewsand
carefullypullthecoverhorizontallybeforeloweringit.
WARNING!
ELECTRICALSHOCKHAZARD.Donottouchuninsulatedwireswhentheinvertercoveris
removed.
AVERTISSEMENT!
RISQUE D’ÉLECTROCUTION, ne touchez pas les fils non isolés lorsque le couvercle de l'onduleur
est retiré.
3.
Activatetheinverter:
a. VerifythatthecardS/NmatchestheinverterS/N.
b. Insertthecardintotheslotmarked"CARD"onthecommunicationboard.
c. TurnACON.
d.
LCDshows:Running Script...èDone!
Figure 19: Communication board and activation card
IfLCDshows:Failed:
l TurnACOFFandON(reset),andrepeattheactivationprocess.
l Usetheactivationcodethatappearsonthecertificationinverterlabeltomanuallyactivatethe
inverter.
l Iftheproblempersists,contactSolarEdgeSupport.
NOTE
Youcanusetheactivationcodethatappearsonthecertificationinverterlabeltoactivate
theinverterincaseofascripterrororamissingactivationcard.
4. Verifythattheinverterisconfiguredtothepropercountry:Presstheupordownbuttonsuntil
reachingtheIDstatusscreen:
D S P 1 / 2 : 1 . 0 2 1 0 / 1 . 0 0 3 4
C P U : 0 0 0 3 . 1 9 x x
C o u n t r y : U S A 1
Single Phase Inverter with HD-Wave Technology Installation MAN-01-00306-1.1
32
Chapter 5: Commissioning the Installation