Installation Guide

6.
Hangtheinverteronthebracket:Lifttheinverterfromthesides,orholditatthetopandbottomof
theinvertertolifttheunitintoplace.DonotliftholdingtheSafetySwitchasitmaybedamaged.
Lowertheinvertersothatthenotchesontheinverterbracketsareinsertedintheholesofthewall
brackets,asshownbelow.
Figure 15: Hanging the inverter on the bracket
7.
Optionally,securetheDCSafetyUnitbrackettothewall/pole,using1-3screws:
NOTE
IncaseofinverterreplacementwiththeDCSafetyUnitstillmounted,itisrecommendedtouseall
3holes.
a.
MarkthelocationofthebracketscrewfortheSafetySwitch,andoptionallythetwo
additionalbracketholes.

Figure 16: Safety Switch bracket
b. Removetheinverterfromthewall/pole.
c. DrilltheholefortheSafetySwitchbracket.
d. Hangtheinverteronthemountedbrackets.
e. FastentheSafetySwitchbracketusingastandardbolt.
Chapter 3: Installing the Inverter
Single Phase Inverter with HD-Wave Technology Installation MAN-01-00306-1.1
27