Installation Guide

NOTE
Makesurethemountingsurfaceorstructurecansupporttheweightoftheinverter.
CAUTION!
SolarEdgeinverterscanbeinstalledataminimumdistanceof50m/164ftfromtheshorelineofan
oceanorothersalineenvironment,aslongastherearenodirectsaltwatersplashesontheinverter.
AVERTISSEMENT!
Les onduleurs SolarEdge peuvent être installés à une distance minimum de 50m de la ligne d'eau de
l'océan ou autre environnement salin, tant qu'il n'y a pas d'éclaboussements d'eau salée directs sur
l'onduleur.
1. Determinetheinvertermountinglocation,onawall,studframingorpole.Itisrecommendedto
mounttheinverterinalocationprotectedfromdirectsunlight.
2. Toallowproperheatdissipation,maintainthefollowingminimumclearanceareasbetweenthe
inverterandotherobjects:
l Ifinstallingasingleinverter:

o
8"(20cm)fromthetopoftheinverter.

o
Atleast
4"(10cm)fromthebottomoftheinverter;ifconduitentrytotheSafetySwitchwill
befromthebottom,leavesufficientclearancefortheconduitsaswell.

o
4"(10cm)fromtherightandleftoftheinverter.
l Ifinstallingmultipleinverters:

o
Wheninstallinginvertersoneaboveoftheother,leaveatleast12"(30cm)betweeninverters.
3.
Theinverterbracketsareattachedtothedesignatedheatsinkfinsreadyforwallmounting.For
installationonapole,removethetwobracketsandattachthemtothecentralheatsinkfinone
belowtheother(donotovertightensothebracketheightcanbeadjusted).
Figure 14: Mounting the inverter brackets
4. Positionthewallmountingbracketsagainstthewall/poleandmarkthedrillingholelocations(refer
toMechanicalSpecificationsonpage70forinverterandmountingbracketdimensions).
5. Drilltheholesandmountthebrackets.Verifythatthebracketsarefirmlyattachedtothemounting
surface.
Single Phase Inverter with HD-Wave Technology Installation MAN-01-00306-1.1
26
Mounting the Inverter