Installation Guide

2.
LoosenthescrewsonthefrontcoveroftheSafetySwitch,asshownbelow:

Figure 11: Opening the Safety Switch cover
3. RemovetheSafetySwitchcover.
4.
OpentherequiredACandDCconduitdrillguidesaccordingtotheconduitsusedintheinstallation:
Thedrillguidesarelocatedatthebottomandsidesoftheenclosure,eachwithtwosizes:¾''and1''.
Opentherequireddrillguides,takingcarenottointerferewithanyoftheinternalcomponents.Itis
recommendedtouseaUnibitdrill.
Figure 12: Safety Switch drill guides
NOTE
Unusedconduitopeningsandglandsshouldbesealedwithappropriateseals.
Mounting the Inverter
Themountingbracketskitincludesthefollowingparts:
l Twobracketsformountingonawall/pole(screwsnotincluded)
l Twoscrewswithwashersforfasteningtheinverterbracketstothewallbrackets.
Figure 13: Mounting brackets and screws
Chapter 3: Installing the Inverter
Single Phase Inverter with HD-Wave Technology Installation MAN-01-00306-1.1
25