Installation Guide

CAUTION!
When removing the cover, make sure not to damage internal components.
SolarEdge will not be held responsible for any components damaged as a
result of incautious cover removal.
ATTENTION!
Lors du retrait du couvercle, assurez-vous de ne pas endommager les
composants internes. SolarEdge ne peut être tenue pour responsable des
composants endommagés à la suite d'une imprudence dans le retrait du
couvercle.
5. Disconnect all DC, AC wires and the communication connectors from the Primary
Unit.
Figure 49: Primary Unit interface
6.
Unscrew the two conduit nuts in the Primary Unit securing it to the Connection Unit.
Figure 50: Conduit nuts
7. Remove the screw securing the Primary Unit to the mounting bracket and remove
the Primary Unit from the mounting bracket.
NOTE
If you remove the Primary Unit and do not immediately install a new one,
then:
Lock the Connection Unit in the OFF position using a lock on the switch.
Use insulation tape to isolate each of the AC and DC wires.
Seal the open conduits using duct tape.
Three Phase Inverter with Synergy Technology Installation MAN-01-00401-1.5
94 Replacing the Primary Unit