Installation Guide

Figure 18: Brackets spacing
If you are using the level:
a. Drill two holes for each bracket and mount the brackets.
b.
Place the level beneath the brackets and align the brackets, tighten the screws
all the way and verify that the brackets are firmly attached to the mounting
surface.
Figure 19: Aligning the brackets
c. Position the mounting brackets against the wall and mark the required drilling
holes locations with the supplied level. The level markings correspond to a
distance of 3 cm between units.
d. Put in the screws without tightening in order to correct positioning.
4. Mount the Primary Unit bracket and put in the screws.
5. Tighten the Primary Unit screws all the way and verify that the bracket is firmly
attached to the mounting surface.
6.
Mount the Primary Unit:
Chapter 3: Installing the Primary and Secondary Unit(s) 39
Three Phase Inverter with Synergy Technology Installation MAN-01-00401-1.5