Installation Guide

CAUTION!
HEAVY OBJECT. To avoid muscle strain or back injury, use proper lifting
techniques, and if required - a lifting aid.
ATTENTION
Objet lourd. Pour éviter la fatigue musculaire ou des blessures au dos, utilisez
des techniques de levage appropriées et, si nécessaire - un auxiliaire de levage
lors du retrait.
CAUTION!
SolarEdge inverters can be installed at a minimum distance of 50 m/ 164 ft from
the shoreline of an ocean or other saline environment, as long as there are no
direct salt water splashes on the inverter.
 AVERTISSEMENT!

Les onduleurs SolarEdge peuvent être installés à une distance minimum de 50m
de la ligne d'eau de l'océan ou autre environnement salin, tant qu'il n'y a pas
d'éclaboussements d'eau salée directs sur l'onduleur.
1. Determine the inverter mounting location, on a wall or stud framing . It is
recommended to mount the inverter in a location protected from direct sunlight.
2.
To allow proper heat dissipation, maintain the following minimum clearance areas
between the inverter and other objects:
NOTE
The Primary unit is longer than the Secondary Unit, therefore make sure the
mounting location is high enough to fit the Primary Unit and leaves
sufficient space for cable entry.
If installing a single inverter:
8" (20 cm) from the top of the unit.
At least 4" (10 cm) from the bottom of the Connection Unit; if
conduit entry to the Connection Unit will be from the bottom, leave
sufficient clearance for the conduits as well.
1.2" (3 cm) from the right and left of the unit.
If installing multiple inverters:
When installing inverters one above of the other, leave at least 12"
(30 cm) between inverter. When installing the Primary Unit , leave 20
cm (8") between the top of an Primary Unit and the bottom of the
Connection Unit.
When installing inverters side by side:
Chapter 3: Installing the Primary and Secondary Unit(s) 37
Three Phase Inverter with Synergy Technology Installation MAN-01-00401-1.5