Install Manual
Table Of Contents
- Disclaimers
- Revision History
- HANDLING AND SAFETY INSTRUCTIONS
- IMPORTANT SAFETY INSTRUCTIONS
- Chapter 1: Overview
- Chapter 2: Installing the Power Optimizer
- Chapter 3: Installing the Inverter
- Chapter 4: Installing the Battery
- Chapter 5: Connecting the Inverter
- Chapter 6: Activating, Commissioning and Configuring the System
- Chapter 7: Setting Up Communication to the Monitoring Platform
- Appendix A: Errors and Troubleshooting
- Appendix B: Mechanical Specifications
- Appendix C: Replacing and Adding System Components
- Appendix D: Powering the LG Chem Battery Off and On
- Single Phase Energy Hub Inverter with Prism Technology - Technical Specificat...
- Support Contact Information
Figure 24: Connecting two Energy Hub inverters
3. On the second inverter, connect the cable to either the 2nd Inv RS485 connector or
the SMRT EV RS485 connector.
4. On both inverters, pass the 12V- RSD cable through Communication gland 2 and
connect it to the 2nd Inv-Battery connector.
5. Pull the cables lightly to make sure they are properly connected.
6. Close and tighten the communication glands.
To connect an additional HD-Wave inverter:
1. On the HD-Wave inverter, connect one end of the communication cable to the
RS485-1 connector on the communication board. For more information, refer to the
HD-Wave inverter Installation Guide
.
2. Pass the other end of the communication through Communication gland 2 of the
Energy Hub inverter.
3. Connect the cable to the 2nd Inv RS485 connector on the communication board.
4. Pull the cables lightly to make sure they are properly connected.
5. Close and tighten the communication glands.
Single Phase Energy Hub Inverter with Prism Technology MAN-01-00671-1.2
44 Connecting Multiple Inverters through RS485