Install Manual
Table Of Contents
- Disclaimers
- Revision History
- HANDLING AND SAFETY INSTRUCTIONS
- IMPORTANT SAFETY INSTRUCTIONS
- Chapter 1: Overview
- Chapter 2: Installing the Power Optimizer
- Chapter 3: Installing the Inverter
- Chapter 4: Installing the Battery
- Chapter 5: Connecting the Inverter
- Chapter 6: Activating, Commissioning and Configuring the System
- Chapter 7: Setting Up Communication to the Monitoring Platform
- Appendix A: Errors and Troubleshooting
- Appendix B: Mechanical Specifications
- Appendix C: Replacing and Adding System Components
- Appendix D: Powering the LG Chem Battery Off and On
- Single Phase Energy Hub Inverter with Prism Technology - Technical Specificat...
- Support Contact Information
NOTE
Make sure the mounting surface or structure can support the weight of the
inverter.
CAUTION!
SolarEdge inverters and power optimizers can be installed at a minimum
distance of 50 m/ 164 ft from the shoreline of an ocean or other saline
environment, as long as there are no direct salt water splashes on the inverter or
power optimizer.
ATTENTION!
Les onduleurs SolarEdge peuvent être installés à une distance minimum de 50m
de la ligne d'eau de l'océan ou autre environnement salin, tant qu'il n'y a pas
d'éclaboussements d'eau salée directs sur l'onduleur.
1. Determine the inverter mounting location, on a wall, stud framing or pole. It is
recommended to mount the inverter in a location protected from direct sunlight.
2.
To allow proper heat dissipation, maintain the following minimum clearance areas
between the inverter and other objects:
Figure 12: Clearance areas
If installing a single inverter:
8" (20 cm) from the top of the inverter.
At least 4" (10 cm) from the bottom of the inverter; if conduit entry to the
Connection Unit will be from the bottom, leave sufficient clearance for the
Chapter 3: Installing the Inverter 31
Single Phase Energy Hub Inverter with Prism Technology MAN-01-00671-1.2