Energy Hub with Prism Technology Installation Guide
Table Of Contents
- Disclaimers
- Revision History
- HANDLING AND SAFETY INSTRUCTIONS
- IMPORTANT SAFETY INSTRUCTIONS
- Chapter 1: Overview
- Chapter 2: Installing the Power Optimizer
- Chapter 3: Installing the Inverter
- Chapter 4: Installing the Battery
- Chapter 5: Connecting the Inverter
- Chapter 6: Activating, Commissioning and Configuring the System
- Chapter 7: Setting Up Communication to the Monitoring Platform
- Appendix A: Errors and Troubleshooting
- Appendix B: Mechanical Specifications
- Appendix C: Replacing and Adding System Components
- Appendix D: Powering the LG Chem Battery Off and On
- Single Phase Energy Hub Inverter with Prism Technology - Technical Specificat...
- Support Contact Information
Chapter 5: Connecting the Inverter
This chapter explains how to connect the inverter to:
AC grid
DC strings of modules with power optimizers
Smart EVCharger
Battery
Installing Conduits
Before connecting the inverter, install all conduits in the following order.
Figure 15: Conduit installation
To install a conduit:
1. Switch the DCSafety Switch to OFF.
2.
Release the four Allen screws of the Connection Unit cover and remove the cover.
CAUTION!
When removing the cover, make sure not to damage internal
components. SolarEdge will not be held responsible for any components
damaged as a result of incautious cover removal.
3.
Install a conduit of the required diameter:
To install a 1" conduit, remove the conduit plug together with the reducing
washer.
To install a 3/4" conduit, use the reducing washer.
4. If required, ground the conduit by connecting it to the grounding bar, as shown
above.
Single Phase Energy Hub Inverter with Prism Technology MAN-01-00671-1.3
36 Chapter 5: Connecting the Inverter