Install Manual
Table Of Contents
- Disclaimers
- Revision History
- Contents
- HANDLING AND SAFETY INSTRUCTIONS
- IMPORTANT SAFETY INSTRUCTIONS
- Chapter 1: Introducing the SolarEdge Power Harvesting System
- Chapter 2: Installing the Power Optimizer
- Chapter 3: Installing the Inverter
- Chapter 4: Connecting the AC and the Strings to the Safety Switch
- Chapter 5: Activating, Commissioning and Configuring the System
- Chapter 6: Setting Up Communication to the Monitoring Platform
- Appendix A: Errors and Troubleshooting
- Appendix B: Mechanical Specifications
- Appendix C: External Fan Maintenance and Replacement
- Appendix D: Replacing and Adding System Components
- Determining the Circuit Breaker Size
- Support Contact Information
The inverter is supplied with a mounting bracket.
Figure 15: Mounting bracket
NOTE
Make sure the mounting surface or structure can support the weight of the
inverter and bracket, and make sure that it spans the width of the bracket.
CAUTION!
HEAVY OBJECT. To avoid muscle strain or back injury, use proper lifting
techniques, and if required - a lifting aid.
ATTENTION!
Objet lourd. Pour éviter la fatigue musculaire ou des blessures au dos, utilisez
des techniques de levage appropriées et, si nécessaire - un auxiliaire de levage
lors du retrait.
CAUTION!
SolarEdge inverters and power optimizers can be installed at a minimum
distance of 50 m/ 164 ft from the shoreline of an ocean or other saline
environment, as long as there are no direct salt water splashes on the inverter or
power optimizer.
For SolarEdge inverters installed at a distance of 200 m / 655 ft. or closer to the
shoreline, special brackets purchased separately from SolarEdge and SS304
stainless screws are required.
ATTENTION!
Les onduleurs SolarEdge peuvent être installés à une distance minimum de 50m
de la ligne d'eau de l'océan ou autre environnement salin, tant qu'il n'y a pas
d'éclaboussements d'eau salée directs sur l'onduleur.
Pour les onduleurs SolarEdge installés à une distance de 200 m ou moins du
rivage, des supports spéciaux achetés séparément auprès de SolarEdge et des
vis inox SS304 sont nécessaires.
1. Determine the inverter mounting location, on a wall, stud framing or pole. It is
recommended to mount the inverter in a location protected from direct sunlight.
Chapter 3: Installing the Inverter 35
Three Phase System Installation Guide MAN-01-00527-1.4