Install Manual
Table Of Contents
- Disclaimers
- Revision History
- Contents
- HANDLING AND SAFETY INSTRUCTIONS
- IMPORTANT SAFETY INSTRUCTIONS
- Chapter 1: Introducing the SolarEdge Power Harvesting System
- Chapter 2: Installing the Power Optimizer
- Chapter 3: Installing the Inverter
- Chapter 4: Connecting the AC and the Strings to the Safety Switch
- Chapter 5: Activating, Commissioning and Configuring the System
- Chapter 6: Setting Up Communication to the Monitoring Platform
- Appendix A: Errors and Troubleshooting
- Appendix B: Mechanical Specifications
- Appendix C: External Fan Maintenance and Replacement
- Appendix D: Replacing and Adding System Components
- Determining the Circuit Breaker Size
- Support Contact Information
NOTE
A SolarEdge inverter may be installed in a site with a generator. SolarEdge
requires installing a physical or electronic interlock, which will signal to the
inverter when the grid has been disconnected. Interlock procurement,
installation, maintenance and support are the responsibility of the installer.
Damage to the inverter due to incorrect interlock installation or use of an
interlock that is incompatible with the SolarEdge system will render the
SolarEdge warranty invalid.
For more information, refer to
https://www.solaredge.com/sites/default/files/se-inverter-
support-of-voltage-sources.pdf.
IMPORTANT SAFETY INFORMATION
Building or structures with both utility service and a PV system, complying
with NEC 690.12, shall have a permanent plaque or directory including the
following wording:PHOTOVOLTAIC SYSTEM EQUIPPED WITH RAPID
SHUTDOWN. The term “PHOTOVOLTAIC” may be replaced with “PV.” The
plaque or directory shall be reflective, with all letters capitalized and having a
minimum height of 9.5mm (3/8 in.) in white on red background.
Attention -The system status indicator shall be installed in a location in close
proximity to the system actuator, where the indication of safe shutdown can
be clearly seen.
This rapid shutdown system is required to be provided with an actuating
device or a status indicator which shall be installed in a location accessible to
first responders, or be connected to an automatic system which initiates rapid
shutdown upon the activation of a system disconnect or activation of
another type of emergency system.
Additionally, in a prominent location near the actuator device the end use
installation shall be provided with a permanent marking including the
following wording:PHOTOVOLTAIC SYSTEM EQUIPPED WITH RAPID
SHUTDOWN. The term “PHOTOVOLTAIC” may be replaced with “PV”. The
plaque or directory shall be reflective, with all letters capitalized and having a
minimum height of 9.5mm (3/8 in.) in white on red background.
Three Phase System Installation Guide MAN-01-00527-1.4
10 IMPORTANTSAFETYINSTRUCTIONS