Installation Manual

To connect the RS485 communication bus:
1. Openthecommunicationgland.
CAUTION!
The gland includes a rubber waterproof fitting, which should be used to ensure proper sealing.
Le cote interne du gland contient une rondelle qui doit être utilisée pour une bonne étancheïté.
2. RemovetherubberfittingfromtheglandandinserttheCAT5/6cablethroughtheglandandthrough
theglandopeningintheConnectionUnit.
3. Removethesealfromoneoftheopeningsinthecommunicationglandandinsertthewirethrough
theopening.
4.
Pulloutboth3-pinRS485terminalblocks,asshownbelow:
Figure 36: RS485 connectors and termination switch
Three Phase Inverter with synergy technology Guide MAN-01-00401-1.1
65
Creating an RS485 Bus Connection