Installation Manual

Chapter 3: Configuring Cellular Communication

CDMA Cellular Installation Guide - MAN-01-00194-1.3

6 Exit the Setup mode by selecting the Exit option in each

submenu screen, or wait for the inverter to automatically exit

Setup mode if no buttons are pressed for more than two

minutes.

Verifying the Connection

The modem communicates with the SolarEdge monitoring portal

every several hours and sends all monitoring data accumulated since

last communication.

1 Check the server communication status screen:

S e r v e r : C e l l < S _ O K >

S t a t u s : <OK>

S i g : 5

< E r r o r m e s s a g e >

 Server: The method of communication to the SolarEdge

monitoring portal. Should display Cell.

 Status: Displays OK if the inverter established a successful

physical connection to the Cellular modem.

 S_OK: The last communication to the SolarEdge

monitoring portal was successful (appears if the inverter

is connected to the portal). If S_OK is not displayed, refer

to Troubleshooting, on page 19).

 Sig: The signal strength, received from the cellular

modem. A value between 0-5, (0 = no signal, 5 = excellent

signal).

 Error message per communication connection status

failure (Refer to Troubleshooting, on page 19).

2 Close the inverter cover as described in its manual. Verify

proper cover fastening to ensure sealing.