Installation Manual

Chapter 3: Configuring Cellular Communication

CDMA Cellular Installation Guide - MAN-01-00194-1.3

Chapter 3: Configuring Cellular

Communication

This chapter describes how to configure the inverter to use CDMA,

verify the connection and troubleshoot problems.

Configuring the Inverter Using the LCD Light

Button

The following figures illustrate the inverter connector panel types:

Figure 12: Inverter connector panel types

Use the LCD button to toggle through the informative status screens,

and for communication setup.

1 Verify that the inverter ON/OFF switch is OFF.

2 Press the LCD light button once to turn ON the backlight.

If the inverter was in production mode before this action, the

following message is displayed:

D C V O L T A G E N O T S A F E

D O N O T D I S C O N N E C T

V D C : 7 2 . 0

This message is displayed until the DC is below the safety

voltage threshold. The default safety voltage is 50V.

On/Off Switch LCD Button