Installation Manual

Chapter 2: Installing the Cellular Modem and Antenna

CDMA Cellular Installation Guide - MAN-01-00194-1.3

Installing the Antenna and Cable

1 Connect the antenna to the mounting clip, and tighten by

screwing the antenna to the clip.

Figure 2: Connecting the antenna to the mounting clip

2 Attach the mounting clip with the antenna vertically to the top

of the inverter. You may attach the clip to the heat sink fins or

the inverter side.

Figure 3: Antenna mounted on the inverter

If not mounting the antenna on the inverter, install the clip on

the wall using two screws (not supplied). The antenna must be

vertical and have a radial clearance of at least 2.7"/7 cm from

metal surfaces.

3 Route the antenna cable along the inner fins or the inverter

side, in the bracket. Make sure the cable is not hanging loose

outside the inverter enclosure.

Single phase inverter Extended power single phase/

Three phase inverter