Installation

Troubleshooting
You can check for connectivity errors by observing the LED indications in
troubleshooting mode.
This functionality is unavailable during pairing or if pairing failed.
To activate the error display:
Short-press the push-button (< 1 sec). The LED color changes in the following
sequence:
Color1 blinks è 0.25 sec pause è Color1 blinks è 0.5 sec pause è Color2 blinks è
0.25 sec pause è Color2 blinks.
The following table summarizes the colors and their indications, and how to
troubleshoot errors.

Color 1 Color 2
Error
#
Description Troubleshooting
Red
Orange
1
LAN
disconnected
Check the cable pinout assignment and cable
connection.
Refer to Creating an Ethernet (LAN) Connection in
the inverter installation guide .
No downlink
Wi-Fi
reception
No downlink Wi-Fi connection detected by the
Repeater.
Check that the Repeater is plugged in, or reduce
the distance between the devices.
Red
Blue
2
DHCP Failed,
or Invalid
DHCP
configuration
IP settings problem.
1. Check the router configuration.
2. Reset the Gateway.
Consult with your network provider.
Orange Red
3
Ping to
router failed
Check the physical connection to the router.
Check that the link LED at the router is lit
(indicating physical link).
If OK - contact your network provider, otherwise
replace the cable or change it from cross to
straight connection.
Wireless Gateway and Wireless Repeater Installation Guide MAN-01-00559-1.6
20 Chapter 4: Status, Errors and Troubleshooting