Installation

To continue later, select Continue Later. If this option is chosen, the home
owner should connect the devices to the electrical outlets and the router
later on, at their own discretion.
i. After all devices are installed, verify that the blue LED on the Wireless Gateway is
ON, which indicates the communication between the inverter and the
monitoring platform has been established.
j. If connection failed, or after 2 minutes of attempts to connect, SetApp displays
a failure indication and troubleshooting text. The LED will indicate the device
status as described in LEDIndications on page 9. For troubleshooting, refer to
"Status, Errors and Troubleshooting " on page13.
k. If required, repeat the above steps for additional inverters.
NOTE
If pairing must be performed, set the Wireless Gateway channel to 6 on the
Maintenance web page, or perform a factory reset, as described in "Factory
Reset" on page22.
Wireless Gateway and Wireless Repeater Installation Guide MAN-01-00559-1.6
12 Chapter 3: Connection and Configuration