Installation

Chapter 2: Wireless Gateway Interfaces
Figure 5: Wireless Gateway interfaces
Push-button
The Wireless Gateway is equipped with a configuration push-button, which is used for:
Accessing troubleshooting mode. Refer to Troubleshooting on page 20.
Enabling a mobile device (for example: smart phone, tablet) to access a web page
for maintenance.
Factory reset
The push button is illuminated by LEDs. The LEDindications are summarized in the next
section. The following sections describe the push-button functionality.
LEDIndications
The following table describes the LEDcolor indications for the Wireless Gateway or
Repeater:
Color Status Indication
 Red
OFF No power
ON General error
Blinking
During factory reset
Blue
ON
Communication between the Wireless Gateway or
Repeater and the monitoring platform is OK
Blinking
No communication between the Wireless
Gateway/Repeater and the downlink Repeater/ inverter

Chapter 2: Wireless Gateway Interfaces 9
Wireless Gateway and Wireless Repeater Installation Guide MAN-01-00559-1.6