Installation Guide
Modbus Address ID 1 ID 2 ID 3
5 Up Down Up
6 Down Up Up
7 Up Up Up
Termination DIPswitches
The Termination DIPswitches are used to configure RS485 wiring termination. The
termination options are listed in the table below. See the figure
ID and Termination DIP
Switches
on page 9 for switch direction guidelines.
RS485 Termination TERM 1 TERM 2
Terminated (factory default) N/A Down
Not Terminated N/A Up
Figure 4: ID and Termination DIP Switches
Meter Connection
The SolarEdge inverter or the Commercial Gateway reads the exported/imported power
from a meter installed at the grid connection point or reads the consumption from a
meter installed at the load consumption point.
Chapter 1: Introduction 9
Energy Meter with Modbus Connection MAN-01-00270-1.3